Application with brush/roller.
CONCRETE SURFACES: Wait until completely set (min 1 month). The surface must be completely dry. The humidity of the floor must not exceed 4%, measured at a depth of 2 cm. The surface must be firm and free of dust, laitance or grease and poorly adhered parts. Minimum tensile strength 15 kg/cm².
Remove grease and rubber stains with thinners or detergents, then rinse off the detergent with water. Use shot blasting and milling if stains do not disappear.
Laitance and curing agents must be removed by shot blasting and milling, subsequently vacuuming the resulting dust, to obtain a rough surface free of foreign materials.
The surface to be painted must have sufficient roughness to ensure adherence. It is advisable to carry out a preliminary test patch on a representative area (1m²) to ensure compatibility and desired result.
Stir paint thoroughly until completely homogenized.
Apply on consistent, clean surfaces, free of efflorescence (saltpetre) and mould.
It is not advisable to apply the product on surfaces that are damp or excessively heated by the sun.
Dilute according to porosity and state of the surface.
MIXTURE PREPARATION: Stir component A in its container and once homogenized, add component B slowly to it, while mechanically stirring at low speed. Shake for 2 minutes until perfectly homogenized. If necessary, pour mixture into a new container, and stir again to guarantee a mixture that is as homogeneous as possible. Do not use the mixture after exceeding product's potlife of 8 hours.
For more information consult TDS.